INSPECTION

1.	Check that the red light flickers when the door lock button or unlock button is pressed on the transmitter.

2.	Remove the battery and check voltage if the red light doesn't flicker.

Standard voltage : 3V

1.	Replace the battery if voltage is below 3V and replace the remote control switch if it is inoperable after replacing the battery. Battery : Lithium CR2032 (3V, 220mA/h)

TRANSMITTER CODE SAVING METHOD

1.	To store transmitter code, first connect the hi-scan (pro) to the Data Link Connector (DLC) in driver side crash pad lower panel.

2.	Turn the power on hi-scan (pro) with the ignition switch ON.

3.	Select the vehicle model on hi-scan (pro).

4.	After selecting "CODE SAVING" menu then button "ENTER" key.

5.

Proceed as follow steps and then code saving is completed. (1) Press [ENTER] key, if you are ready. (2) Press the transmitter [LOCK] button above 1 second. (3) If you save transmitter one more, press other transmitter [LOCK] button above 1 second. (4) Turn the hi-scan (pro) off, and check the keyless entry system.

INSPECTION

1.	Check that the red light flickers when the door lock button or unlock button is pressed on the transmitter.

2.	Remove the battery and check voltage if the red light doesn't flicker. Standard voltage : 3V

3.	Replace the battery if voltage is below 3V and replace the remote control switch if it is inoperable after replacing the battery. Battery : Lithium CR2032 (3V, 220mA/h)

PROGRAMMING TRANSMITTER CODE

1.	To program the transmitter code, first connect the hi-scan (pro) to the Data Link Connector (DLC) in drive side crash pad lower panel.

2.	Turn the power on hi-scan (pro) with the ignition switch ON.

3.	Select the vehicle model on hi-scan (pro).

4.	After selecting "CODE SAVING" menu then button "ENTER" key.

5.

Proceed as follow steps and then code saving is completed. (1) Press [ENGER] key, if you are ready. (2) Press the transmitter [LOCK] button above 1 second. (3) If you save transmitter one more, press other transmitter [LOCK] button above 1 second. (4) Turn the hi-scan (pro) off, and check the keyless entry system.